When nothing seemed to go right on several workovers of recently acquired older wells, MaxCam was called to run a camera and find what the problem was. It was found that the schematics the operator had for the older wells were quite inaccurate. What the camera showed and what the schematics showed were very different.

MaxCam was called out to hunt for an elusive cable fish with its camera and the problem causing species was found and removed. While the cable fish is a great catch it is terrible eating.

After attempting to mill thru an obstruction and still not being able to get past, the operator ran a camera to inspect the AOI. It was found that the casing had collapsed, and the milling operation cut a window into the casing. The camera shows views from inside the casing and open hole.

After running a camera which identified a plug as the source of an obstruction, the operator milled the plug to remove it and ran the camera again to check the results. It was then found that the reason the plug had been lodged in the first place was due to parted casing.